Single hung
Double hung
Horizontal roller
Casement
Bay & bow
Sliding glass doors
Entry doors
Impact garage doors
PGT
CGIFree in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Get your free estimateES Windows Custom & Geometric Windows in Whitney: What to Know First
We provide independent ES Windows custom and geometric window service in Whitney, and most jobs run one to three weeks from measurement to final inspection because arched, radius, and oversized units are built to the opening, not pulled from a shelf. Custom ES Windows impact units for Whitney homes typically land between $1,100 and $3,800 per window, but we don’t quote until we’ve measured and shadowed the frame. Every estimate is a written line-item quote before anything is ordered.
This page is for Whitney homeowners who already have ES Windows products in the wall – arched transoms over an entry, radius-topped units on a two-story face, oversized sliders, or trapezoid windows tucked under a gable – and need repair, replacement, or a new custom unit matched to the existing facade. As an independent ES Windows service provider, we’re not affiliated with or authorized by ES Windows. We install and service their products because they hold up in Whitney’s heat and wind, not because anyone handed us a badge to say so. Call (844) 797-3297 to get a free estimate on the calendar.
How ES Windows Products Fail – and How We Fix Them
ES Windows builds a solid custom product, but Whitney’s climate is hard on shaped and oversized glass, and the failures we see here are specific. Here’s what actually goes wrong and what we do about it.
- Seal creep at the radius on ES Windows arched and eyebrow units. On curved and radius-top windows, the glazing seal at the tightest part of the curve is the first thing to give. Whitney’s summer swings from 105°F afternoons to 75°F nights pull the seal tape loose over a few seasons, and the symptom is a thin line of fog near the apex that grows downward. We reset the unit with a UV-stable glazing seal rated for that expansion cycle rather than a generic silicone that hardens and cracks.
- Frame racking on ES Windows oversized openings. When an opening wider than about 8 feet was framed without a proper king stud and header, the ES Windows frame takes the load and slowly racks out of square. Homeowners usually notice the sash dragging or a gap at the top corner before they notice the framing. We check square with a laser, shim and re-anchor correctly, and tell you honestly when the framing is the real problem.
- Weep and drainage failure on geometric units. Trapezoid, triangular, and gable-end shapes put the weep system in odd geometry, and on ES Windows shaped units the sill weep holes can clog with Whitney’s windblown fine dust and sand. Water sits, then the frame corrodes at the bottom corner. We clear, re-cut weep paths, and add splash guards where the shape traps water.
- Impact film and lamination breakdown on ES Windows impact glass. Impact-rated laminated glass on a custom or oversized unit is heavy, and if any edge delamination starts the glass loses rating on that window. The symptom is a milky haze creeping in from one edge. We identify it early, document it for the warranty, and handle the replacement so the paperwork is clean.
- Hardware and operator fatigue on large custom units. Big casements, awning, and multi-panel units carry more weight than standard sizes, so ES Windows operators and hinges wear faster. We swap to OEM-balanced hardware where it’s still made, or a quality aftermarket operator sized for the actual sash weight – matching a light-duty operator to a heavy custom sash is how the second failure happens.
Styles & brands we work with
- Single hung
- Double hung
- Horizontal roller
- Casement
- Bay & bow
- Sliding glass doors
- Entry doors
- Impact garage doors
- PGT
- CGI
Our ES Windows Custom & Geometric Windows Process
- 1
Diagnostic visit. We measure every opening and check square, plumb, and level. On shaped units we template the radius so the new unit matches the wall, not a stock size.
- 2
Parts and warranty decision. We pull the ES Windows series information off the unit, walk the OEM-versus-quality-aftermarket trade-off with you, and flag anything that should go through the manufacturer warranty first. No surprise charges.
- 3
Written line-item quote. Glass, frame, hardware, labor, and any framing or stucco touch-up are priced separately so you see what you’re paying for.
- 4
The install or repair. Background-checked, uniformed technicians, correct flashing and sealants for Whitney’s sun and wind, and permits pulled and inspections passed where the job requires it.
- 5
Test and prove it. Operate every unit, check drainage, confirm seals, and have you look before we pack up.
- 6
Backed for good. Our 36500-Day Done Right Promise – a century-long standard. If it’s not done right, we make it right.
See the difference
Before
After
Before
After
Before
AfterWhat ES Windows Custom & Geometric Windows Costs in Whitney
These are the ranges Whitney homeowners see on a written quote. Every job is priced after measurement, so treat this as a starting frame, not a bid.
- Repair of an existing ES Windows custom unit (seal reset, weep clearing, hardware): $180 – $650
- ES Windows impact custom window, standard custom size: $1,100 – $1,900 per unit
- Arched, radius, or eyebrow custom unit: $1,600 – $2,800 per unit
- Oversized or mulled-opening custom unit: $2,200 – $3,800 per unit
- Framing, stucco, or flashing correction: $400 – $1,500 depending on scope
- Permit fees: pass-through, varies by scope
What moves the price: the shape (curves and gables cost more than rectangles), the glass package, the size of the opening, and whether the framing behind the wall gets fixed. Upfront pricing, no change orders after the work starts. Call (844) 797-3297 for a free estimate – the quote is written and line-itemed before we order a thing.
Why Whitney Homeowners Call Winslow Windows & Doors Whitney for ES Windows Work
We’re locally owned and owner-operated, so Ed’s name is on the door and on every job we do. Call any hour and a live person answers – not a call center, not a next-day callback. Our technicians have up to 15 years of experience and they know ES Windows series well enough to spot a radius seal creep from the driveway. Background-checked, uniformed, and identified before the first handshake.
When a job calls for a different brand, we also install and service PGT, CGI, CWS, and ECO Window Systems, so we can match the right unit to the opening instead of forcing one product. Standing offers always available: $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside the home county, and 10% off for seniors and veterans. We’re the one down the road. Call (844) 797-3297.
FAQs
Yes, and we’ll tell you when a repair should go through the ES Windows warranty first rather than through us. We document symptoms – haze, edge delamination, seal failure – so the claim is clean, and we handle the replacement if it falls to us.
Yes. We template the actual radius or shape at the wall so the new unit matches the existing opening and trim line, which is why a custom ES Windows job in Whitney takes one to three weeks instead of a stock swap. Call (844) 797-3297 to get measured.
Repair usually wins if the glass and frame are sound and only the seal, weep system, or hardware failed – expect $180 to $650. Replace when the impact glass itself has delaminated or the frame is racked, since a patch won’t restore the rating.
We use OEM where it’s still made and a quality aftermarket part sized correctly where it isn’t, and we tell you which is which on the quote. Matching an undersized operator to a heavy custom sash is how a second failure gets set up, and we don’t do that.
We answer 24/7 and schedule the diagnostic visit based on the urgency – a security or water-intrusion problem gets moved up. A standard custom replacement is one to three weeks from measurement. Call (844) 797-3297 for the exact timing on your job.
If you have ES Windows custom or geometric windows in Whitney that are fogging, racking, leaking, or just due for replacement, call our team at (844) 797-3297 for a free estimate. A live person picks up any hour, the quote is written line by line, and the work is backed by our 36500-Day Done Right Promise.
Written by the team at Winslow Windows & Doors Whitney, serving Whitney and nearby areas.